Lighting Help with new cob build

[Stinkybudz]

Hi guys, fairly adept when it comes to tinkering with electric. Looking to do a cob build 32 sq feet and was going to do 720 watts approximately running Vero 29 se's. Planned to run 3 sets of 3 36 v 3500k 80 cri type d on 140mm passive pins with surcool thermal pads driven by hlg240h-2100c in series. Have I done my homework correctly? I plan to source from rapid and was also hoping someone could show me how to wire the driver to be 220v input with a 615p plug. Thank you! Genetics are sweet seeds mephisto dinafem short stuff and world of seeds with some photo brother Grimm g13 labs gear and delicious seeds. Thanks AFN. BTW long time lurker haven't been on the forums in about 4 years or so old icmagger. Would 3000k 90 cri Vero 29 se's be better than 3500k 80 cri if used seed to finish on an auto?

 

[BigSm0]

Everything looks good to me. I haven’t ran any vero cobs yet so I did have to double check their specs. The wattage at the cobs should be closer to 680 than 720 but 720 will closer to the wall wattage after the driver. 22.5 watts per square foot is my favorite part! I think you’ll do very well with them.

 

[Jim Ray]

I would go 3500 Kelvin because it is a compromise between vegetative color and flowering color, so you may use the same lights for both stages of growth. I think the front end to the mean well power supply will take whatever voltage you give it, and all you have to do is put the right plug on the end of the wires.


Sent from my iPhone using Tapatalk Pro

 

[BigSm0]

I almost wrote 3500k as well but I’m not sure how the vero spectrum is. For citizen definitely 3500k.