Extraction Rosin Tech Press - Smash

[Builder0101]

Thinking of getting this product. Can anyone advise? Is 4000lbs pressure sufficient? Is the unit dependable...

 

[Mañ'O'Green]

Rosin Tech has been around a while and I am sure you will work. It will take some experimenting with bag, micron and pre-press sizes to get it dialed in. I like the way the plates are guided to remain square. The problem is if you are going to do any kind of volume your arms will be tired from the work out. I am old and have a bum shoulder and it killed me to pump by hand. I have a DIY 3x4 inch plates on a 6 ton A frame press. I installed a pneumatic pump and I am much happier now. I can press 4g of flower at a time two presses for each plug gives the best yield. The first press is 185°F with less pressure then a second press at 210°F maximum pressure. I am using 90 micron bags. It is so monotonous to press. I do not enjoy it but I love the end result.

A link to my DIY is in my signature.

 

[Builder0101]

I think I am settled on a 6 ton manual press.

 

[JSH1973]

I would love a rosin press in the future, is there any of them you can just hook up to a small air compressor instead of manual press?