That'll do. How come it says Cree and Vero for the COBs? Totally different brands. CREE makes the CXA-3070 and CXB-3590s. Bridgelux makes the Vero 29s with the super slick built in holders. I do like me some CREE lights, but man they are like double the price of Citizen and I think the Citis are better anyway. I would go with the Vero if it was me. That built in holder is awesome and I have had a few issues with BJBs making contact correctly. The tolerances on those are shit as some fit better than others. A razor blade is your friend here....take off some plastic and get that thing sitting flush. I had one arcing for awhile and it burned the cob a little. I fixed it, but it's something to be aware of. Also...use Arctic Silver thermal paste instead of the little silicone pads. Way better heat transfer and real easy to use. Use a .177cal BB size dot and a straight edge like a card or razor. My buddy uses a paint brush and swears by it. I use a blade. Just put the dot in the middle and spread it out PAPER thin. .001" thick. As thin as possible with full coverage. A $8 tube should do 25 or more COBs. Most of the people who build lights professionally are using the paste as it's on a whole different level than the pads, and heat is a bad thing with LEDs. Hope all goes smooth in your shopping and assembly. It will be worth it in the end.
There called KAAHBS Joe
Hello again dr bubbles! Turns out they are the bridge lux veros they must overcome fixed that add up now. What's your thoughts
Reckon this should get me going
MAU5 kit is bringing the family meal to grow lighting. This kit has all you need for a cutting edge Grow Room, you will only need to wire up a power cord, mount to some rails and hang it,
just USD1.14 per watt
Kit comprises
4 pcs Bridgelux Vero 18 SE C Voltage bin, with built in solderless Holder
4 Ledil 103 Degree, sealed Optic
4 pcs Graphite Thermal pad(TIM) 1 side adhesive for simple assembly on the COB
1 pc ZPE 250-1400D 250 Watt Dimmable driver allows the 4 COBS to be run at just under 50 watts, the sweet spot of wall plate efficiency( can run 5 COBs max)
4 Passive Pin fin Coolers suitable for the 50 watt drive( based on eff% calculations), predrilled and tapped for the Vero SE and Ledil Silicon Optic( you will only need a screw driver not a drill press)140mm x 80mm
4 Sets of
Heatsink Mount Bracket to mount your heatsinks to rails
24 pcs M3 6mm screws for the Holders
16 pcs M4 12mm Screws for mounting to side rails
5 pcs of Wago 221-412 Terminal Blocks
15 ft of Black and Red Silicon 600V rated 18AWG Wire