Lighting Lights and genetics

[mcubed476]

Beautiful. I remember this one. How is the smoke on her gotta have some going with a good cure by now.

Thanks Mizzo! She is smoking great! The cure should be well established now lol. It's still getting me high, so I would say all is well

 

[mcubed476]

This is unreal. Congratulations my man!

You're telling me. I was just hoping for a lb for the entire grow which consisted of 3 plants. Didn't expect to get 1.5 lbs off one plant lol. Couldn't have done it without my cobs!

 

[BigSm0]

Someday I’ll get a 1lb plant. Lol. My last run I used the new megacrop with calmag. I didn’t read the label and added the same amount of mega and calmag like previous grows. I think the calmag has 14% nitrogen and it didn’t go well at all.

 

[mcubed476]

Someday I’ll get a 1lb plant. Lol. My last run I used the new megacrop with calmag. I didn’t read the label and added the same amount of mega and calmag like previous grows. I think the calmag has 14% nitrogen and it didn’t go well at all.

That is a bummer man, how much megacrop do you give to your plants? In early flower I normally use a 1/2 tsp per gallon, and in later flower I'll use a tsp. Hope your next grow goes better!

 

[BigSm0]

That is a bummer man, how much megacrop do you give to your plants? In early flower I normally use a 1/2 tsp per gallon, and in later flower I'll use a tsp. Hope your next grow goes better!

Growing pain. Need to slow down a bit and read the label next time. The current grow is fantastic. Using the older calmag again with the 2 or 3% nitrogen instead.

 

[AutoWonders]

Need to slow down a bit and read the label next time

I suppose those speed reading classes weren't so good after all eh? I screw something up at least once per grow. Usually jumping a head of myself.

 

[STILLSMOKIN]

Growing pain. Need to slow down a bit and read the label next time. The current grow is fantastic. Using the older calmag again with the 2 or 3% nitrogen instead.

They upped calmag in new solution and its no longer needed. Their goal is a start to finish one product.

 

[Garage_Grower]

They upped calmag in new solution and its no longer needed. Their goal is a start to finish one product.

Still needing to add CalMag to my plants being fed with mc2.0, tried going the whole way without it, but one plant started getting too bad for my liking. Other strain was doing fine with just the mc2 tho.... all strain dependent.


Easy smoking! [emoji869]

 

[STILLSMOKIN]

Still needing to add CalMag to my plants being fed with mc2.0, tried going the whole way without it, but one plant started getting too bad for my liking. Other strain was doing fine with just the mc2 tho.... all strain dependent.


Easy smoking! [emoji869]

Sure its not ph too low or high. They have a bunch in the 2.0

 

[BigSm0]

I have been adding it in with the new 2.0 and haven’t had any problems yet. I do understand why they would try and increase it in their 1 part but with different types of lighting Id think there maybe a need for it with LEDs. Even if it was just a small amount added I’m sure it would never cause an issue. On the other hand the new calmag 2.0 this is more of a base nutrient than a calmag supplement. I’ll never use it again when megacrop