Grow Room Power Strip location idea's and suggestions?

[Badfinger]

Where do you locate your power strip for your tent?
I originally had mine on the floor in the back of the tent, and found this not to be so convenient, due to all the different accessories that come with tent growing.
For me the ideal location is top center. So I picked up a couple clamp fan brackets, installed some screws, and attached my power strip to them.

 

[Trichome farmer]

Where do you locate your power strip for your tent?
I originally had mine on the floor in the back of the tent, and found this not to be so convenient, due to all the different accessories that come with tent growing.
For me the ideal location is top center. So I picked up a couple clamp fan brackets, installed some screws, and attached my power strip to them.

View attachment 1416642
View attachment 1416644
View attachment 1416643

i zip tie mine to a pole at the top of the tent

 

[bad dragon bzzz]

Cone filter +10bhp

 

[Bill.de.Cat]

Same, zip tied to top cross member.

 

[CannabisMingus]

I try to keep all outlets outside the tent - hence the power taps mounted to the wall outside. Also, please don't forget to use a GFCI

 

[Randar]

I rest mine on the outside, top of my tent. Easy peasy.

 

[Jpkindbud]

Back right corner in photo tent, auto tent it's just under extraction fan. In 2x2 closet it's mounted to the wall above the light. Basic rules... Not on the ground, close to all units that require power.

 

[Olderfart]

Where do you locate your power strip for your tent?
I originally had mine on the floor in the back of the tent, and found this not to be so convenient, due to all the different accessories that come with tent growing.
For me the ideal location is top center. So I picked up a couple clamp fan brackets, installed some screws, and attached my power strip to them.

View attachment 1416642
View attachment 1416644
View attachment 1416643

I use two of these, screwed to the outside of my plywood grow drobe:

Mastercraft 8-Outlet Contractor Power Bar Canadian Tire

One supplies heat, the other lights, and the two power bars plug into separate house circuits. That way the load in each circuit is kept to a fraction of capacity. Other miscellaneous stuff including fans and pumps are distributed between the two power bars. Having the bars outside the "drobe allows access to all the plugs without crawling around inside the grow space.

To each, as some say, his or her own.

 

[Badfinger]

Cone filter +10bhp

Hey that's my prefilter
I do need a 25" piece of 1x6 for on top of the tent, to set my filter on. But with the cost of lumber, I thought it would be easier if I waited til the neighbor goes to work, then sneak over and dismantle his porch