DIY DIY cheap efficient gravity bong

[Straight808]

hey guys me and bikini were bored and he was checkin out the site and decided we should make a gravity bong. so, we tried the good old fashion way with some foil and all that dumb shit that you should never do lol. After about 10 minutes of wasting bud on the Jr. high gravity bong, i remembered i had a 6ft plastic POS bong that broke so i went and got the neck and bowl set up from it, and the black rubber gasket as well and i constructed this nice little gravity bong that is super efficient compared to old school ways, it pulls the entire bowl perfectly even just like if you were pulling it from a bong. Im going to be making a new lid now that goes onto a 2 liter bottle tho so we can get obliterated, but basically you just cut a hole into the top of a bottle and put the gasket around the hole, y'all get the point haha it isn't rocket science, but i bet a lot of people waste their old shitty bong parts! enjoy, its gets you RIPPED!

 

[beavergoods]

nice, I love looking at how different people are making these. Here is my version, I've been making these for about 15 years now which has brought me a little experience in getting an airtight seal with just a metal bowl attached to the cup. There are 2 tricks once you master them you're solid. First the diameter of the hole you put in the cap must be smaller than the outside diameter on the bottom of the tap or where the threads are where you screw the bowl into the base. Once you've found the right size hole. I just normally eye this because i dont have a clamp but if you have a clamp and a drill it may be easier. I dig my small hole out the center and then heat that hole up just enough to "snap" and i do get quite a nice "pop" into place. secure the base of the bowl to the surface of the cap snugly and quickly and give it a few minutes to set. That things on there so airtight it actually whistles as it fills up. Also since the bottles here are mostly universal i can change the size of the bottle as i wish but to me 2 litre is the standard.

In this case I've packed a little bit of one of my favorite autoflowers into the bowl.

BeaverG

 

[shumway]

Nice guys :thumbs:

Never tried one before so i decided to make 1 up

Just took me around 3 minutes if that to make a small 1 out of a water bottle and a tobacco canister....lol

Man these things hit nice

 

[Straight808]

hell yeah guys! like beaver said, its important to have an airtight seal or it just doesn't work right! either way seems to work! i made the one in my picture in about 3 minutes like shum! so its super easy

 

[shumway]

Also on a side note its really important to go slow with these fk'ers

Just went a bit too fast with pushing it down and it just about killed me...lol

Started coughing so bad i had a little black out and just about fell out of my chair :no:

 

[surffreak23]

Ha Ha! This reminds me of back in high school when we would just take the cut bottle with the bowl and lean over the stream out back of the school to pull a hit or two at lunch....

 

[Straight808]

Also on a side note its really important to go slow with these fk'ers

Just went a bit too fast with pushing it down and it just about killed me...lol

Started coughing so bad i had a little black out and just about fell out of my chair :no:

Lol I think the hit that made you pass out is kinda what most people are looking for in the gravity bong haha. But yeah, take a slow deep hit for a nice smoother toke, a fast hit for more of the shotgun punch in the face rip followed by choking coughing and crying and getting real high haha

 

[bgrt]

ive always thought of making one from a toilet, put a hole in the cistern with a stem/bowl and a tube for sucking out the smoke. flush for the water drop
never had a toilet to ruin or one that id wanna suck smoke from though.

 

[Straight808]

ive always thought of making one from a toilet, put a hole in the cistern with a stem/bowl and a tube for sucking out the smoke. flush for the water drop
never had a toilet to ruin or one that id wanna suck smoke from though.

Hahaha I'll be waiting for the smoke report!!! Haha

 

[beavergoods]

Nice guys :thumbs:

Never tried one before so i decided to make 1 up

Just took me around 3 minutes if that to make a small 1 out of a water bottle and a tobacco canister....lol

Man these things hit nice

.

They sure do brother!!! Best hits I've ever had thats why I love em!!! And the zero waste factor love that too.

BeaverG