Old Reviews Inkbird Question.

[Unvaccinated]

Guys can advise please, is it possible to run Inkbird as a trip to prevent overheating lights on the temperature side while using the cooling side to run a fan constantly? So using both heating and cooling simultaneously.
hope I explained that

 

[JaxsoNL5]

Short answer no. If i’m understanding correctly you want a fan in the cooling (Work 1?) port and another fan in the other (Work 2) port that turns on to heat the space when things get cold? The temp sensor switches power between the Work 1 and Work 2 settings, so when things get too hot it would shut power off to the heating port. It never sends power to both ports unless it’s telling you it needs to be replaced.

 

[Unvaccinated]

Short answer no. If i’m understanding correctly you want a fan in the cooling (Work 1?) port and another fan in the other (Work 2) port that turns on to heat the space when things get cold? The temp sensor switches power between the Work 1 and Work 2 settings, so when things get too hot it would shut power off to the heating port. It never sends power to both ports unless it’s telling you it needs to be replaced.

@JaxsoNL5 thanks for response, and information.. ok so it looks like I will need to buy a single thermostat plug then. I want to use it to tip the lights incase of overheating in my box.. I know I could use an Ink-bird for this but also wanted the option to continually run my internal fan..
i already have an Ink bird on the heater and extraction covered..
thanks again.