- Joined
- May 4, 2022
- Messages
- 6,981
- Reputation
- 5,873
- Reaction score
- 42,926
- Points
- 0
- Currently Smoking
- Jean0's Kush Kush
Well they are all exploding in growth!
I think he's allowing anything from the squash family since lots of places don't have the typical pumpkins like we have around here.
No I did not know that thank you![]()
And YES serous as a heart attack my very close friend ,coworker, grow buddy ,fishing partner has the tannerite but his neighbor is deer hunting and we don’t want to need his hunting up will be the only issue
Bit soggy..better for Splat factor.........
View attachment 1531532 Hmmmm............hmmmmmm......Who would Trust a Stoner with a pumpkin and explosives......hmmmmmmmmmm................
![]()
Are you gonna blow it up or launch it.........or both? I've got some plate steel. I don't think my roller can handle rolling some strips. I've made simple launch platforms outta 4 pieces of steel. Two squares and two strips rolled to make circles, with top one slightly longer to slip over the other and the strip on the bottom taller to be able to drill the hole for fuse or wires in the side of the bottom piece. .Roll the strips and weld the ends together and then weld to the plate, inside and out.picking up pumpkins todaySourced some tannerite last night just have to make sure I have a safe location
Also thinking off a couple simple back up plans just in case tannerite doesn’t happen
Morning pinky
View attachment 1531516
Bit soggy..better for Splat factor.........
View attachment 1531532 Hmmmm............hmmmmmm......Who would Trust a Stoner with a pumpkin and explosives......hmmmmmmmmmm................
![]()
wasn’t trying to get that in depth just blow it upAre you gonna blow it up or launch it.........or both? I've got some plate steel. I don't think my roller can handle rolling some strips. I've made simple launch platforms outta 4 pieces of steel. Two squares and two strips rolled to make circles, with top one slightly longer to slip over the other and the strip on the bottom taller to be able to drill the hole for fuse or wires in the side of the bottom piece. .Roll the strips and weld the ends together and then weld to the plate, inside and out.
It lasted for quite a few launches until the plates just bowed too much. I used the opportunity to train some NDT and show how to Magnaflux and die penetrate welds.
As the saying goes, be careful what you wish for...Oh because I said so doesn't work on mine lmao. Teaching them to challenge authority has its difficulties![]()