pher beat me to it. Try putting them in the jars and see where you're at, ninja.
Then follow these guidelines from the link that pher posted...
TBM says...
After a couple of hours has passed (takes a bit to get an accurate reading, give it at least 2-4 hrs). Take a look at the RH% reading.
If more than +70% - buds need to dry longer out of the jar. For me, for about every 5% over 70, equals about 10-12 hours outside of jar - but that's different depending on time of year, outside weather, etc... Typically about 12-36 hours more drying time is needed.
65-70% - getting really close to that sweet spot for curing. Keep it in the jars but burp them for a couple of hours, roughly 2-4 hours (meaning - take the lid off). Burp 'em, then close the lid, wait 4-6 hours, check RH%, burp again if needed, repeat as needed until you reach the next level. The closer you get to the next level the longer it takes to get an accurate reading, maybe even 12-24 hours. Basically, after every burp I add about 4-6 hours to the wait time between burps until I check again. Getting it down to the next level might take a week or more, and that's ok. The slower the better. Luckily here in Colorado we have low humidity. If in a higher humidity area, say along the coasts, I would want to speed it up just a bit to get to the next level as mold may become a factor
60-65% - this is the Curing stage range. Once we hit this range, keep things sealed unless we want to prepare it for long-term storage, then we'll need to SLOWLY lower down to the next stage. But if you just want to cure it, leave here in this range for a week and longer to cure. Buds should be slightly sticky. Stems should snap. The RH% may fluctuate a bit as moisture releases from the bud but it will dissipate/be reabsorbed. If this is for retail, I wait about 10-14 days into cure then bring samples to my dispensary buyers. Most dispensaries tend to like it closer to the 65% as it'll cure while it's on the shelf, plus it'll be stickier, look more appealing & that's what most people are looking for - bag appeal. Closer to 60% is better for smoking/vaping. If it's for myself or my patients, I let it cure for at least 2 weeks to a month or more. I do take a bit out to try about once a week. Some of my patients like it a little moister than others as it takes a little longer to smoke. Others don't really care too much one way or the other but no one likes it if too moist or too dry/brittle. Now I also have been implementing those Boveda 65% packets to help keep things where I like it. After about a week of 65% or lower, I slip one of those Boveda 65% packets into the jar, at this point if you want to take the hygrometer out you can. I still burp about once a week or so for about an hour when using those packets, basically just to air out the released chlorophyll gases. I recommend dispensaries use these packets at night in their jars to keep things looking nice & sticky-icky for the next day.
For long term storage - once in this range (60-65), check weekly. If on the higher end, closer to 65, I still burp about every week just for an hour or so. As it slowly drops to 60%, I wait longer & longer between these short burps - we're talking days/weeks here folks not hours between these burps. Once it falls below 60, you have reached the next level. Takes me about 4-6 sometimes 8 weeks.
55-60% - Long term storage stage. I still leave the hygrometer in for about a couple of days/week, just to make sure it's leveled off (unless I have placed a Boveda 65% packet in, then I take the hygrometer out). Once it has leveled off, then I take the hygrometer out & seal the jar. I don't usually storage too much for long term usually just 1 jar per strain per harvest, unless it's just some incredible stuff and I want to be able to share it with long distance friends & family when they visit throughout the year.
If for some reason it reads under 55% - either you left it hanging to dry for too long with a fan blowing on it directly or too close to a heat source/vent or you might need to have a humidifier on a timer in the area you dry in (make sure it's not blowing the moisture directly on plants) OR maybe you just need to wait a little longer for your next reading. Wait 12-24 hours, and check again if still under 55 well you just learn a valuable lesson on how not to dry so quickly next time. It'll be shitty to smoke, guess you could grind it or tumble the heck out of it or maybe make tincture/butter/oil, vaping will probably be ok but smoking it is going to suck. But hey it takes experience, just learn from it....dumbass! LOL! You can re-hydrate a bit with either a Boveda pack (my recommendation) or with things like a bit of orange peel tossed into the jar. The smoke may mellow out & be smoke-able but it won't cure like it's supposed too. If you have never had properly cured cannabis - you're missing out!
Kinda hard to screw up as long as you don't over-dry to begin with. Have patience young jedi...
While your waiting for the reading in the jars, you could read the rest of that very informative thread... :smoke:
i have read the smell goes but will it come back without me having to cure it for months? Im hoping i havent fucked it up and its dried to quick. The humidity has been between 48%-52% and the temps 17-19
