Indoor Qbgrowers perpetual grow in a 4x4 with 480w of Quantum Boards

I use a 2 gal pump sprayer. Makes reach a lot easier.

Just got one of those electric ones that you can put in a bucket. Quite liked it but i'm just going for a 1 litre measuring jug at the moment.

Qb
 
I have one. I've had it since this past winter/spring. I like it but you can easily get caught up in trying to make things perfect but I feel it made a difference. I got it with the wifi controller and bounce between settings.
Good point m8.. its easy to get carried away.. you've gotta be realistic about the best likely conditions you can get i think and try not to end up chasing the impossible as far as your own set up goes. Do you have it set to trigger on temp? Rh? Vpd? Have you tried all 3?
 
Good point m8.. its easy to get carried away.. you've gotta be realistic about the best likely conditions you can get i think and try not to end up chasing the impossible as far as your own set up goes. Do you have it set to trigger on temp? Rh? Vpd? Have you tried all 3?
I kind of use them all at different times. VPD mode is OK but I saw more frequent starts and stops on the fan and with a tent its hard to maintain conditions. I've found Auto mode to have better forgiveness.

Right now its kind of dry in my grow room and temps are dropping outside but it's all good because they are at the end of flower. I have it set to Auto trigger when temps get below 68F/20C and humidity goes above 60%. It doesn't go on much if at all and I'm at average VPD 1.36. I'll be starting up a new run soon so I will probably have to turn on a humidifier and heat the tent because I dim the lights for the first few weeks and they need a lower VPD = warmer/wetter.
 
I kind of use them all at different times. VPD mode is OK but I saw more frequent starts and stops on the fan and with a tent its hard to maintain conditions. I've found Auto mode to have better forgiveness.

Right now its kind of dry in my grow room and temps are dropping outside but it's all good because they are at the end of flower. I have it set to Auto trigger when temps get below 68F/20C and humidity goes above 60%. It doesn't go on much if at all and I'm at average VPD 1.36. I'll be starting up a new run soon so I will probably have to turn on a humidifier and heat the tent because I dim the lights for the first few weeks and they need a lower VPD = warmer/wetter.
Assuming you have one of their controllers m8? Or using separate controls on the heater/light/fan just?
 
Assuming you have one of their controllers m8? Or using separate controls on the heater/light/fan just?
I have there controller but it only runs the heater right now and monitors tent conditions. I have an extraction fan that is constantly running and I only dim my lights for the first week or two. Then it's set at 75% and just let everything grow up to it.
 
Back
Top